The transmitter must be connected with standard two-wire shielded cable. Set parameters H3-0x (Gain) = 231.2% and H3-0x (Bias) = 25.0%. Optionally a secondary 4-20 mA output is available on request. Form Factor: Panel / Chassis Mount, Other. Parties of 20+ are eligible to receive a group discount of 5 per ticket but. Control Signal Output: Analog Voltage, Current Loop. orifice meter located on pipe A, independent P/I transducer, 4-20mAmp transmitter, independent field flow controller, independent 4-20 mAmp I/P transducer, pneumatically operated flow control valve located on pipe B. Active laser trimming of the device thin film resistors results in high levels of. To convert a non Changeable 0-10 Vdc analog input terminal to 4-20 mA signal, connect a 250 Ohm precision resistor (1/4 Watt or greater) between terminals Ax and AC. The jumper selectable 0-10VDC or 4-20mA control output allows the EasyWeb to control a variety of torque devices to regulate web tension including brakes, clutches, and motors. An alarm warns of an open 4-20 mA loop or noncompliance of the output stage.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |